|
Storing your Cover back into the FlagBag
To
store your cover back into the attached FlagBag simply...
- Lay
the cover on
a flat surface.
-
Stretch it out to its full length.
-
Lay the side
panels on top of each other and tuck the top panel in between each side by
folding down the center.
-
The cover should now be laid out so it is approximately
the width of the FlagBag.
-
If not, fold any excess width towards
the center.
- Now
go to the nose (the end of the bag opposite of the Flagbag) and fold
the nose back to the opening of the FlagBag, Essentially, you are
folding the cover in half.
- Continue to fold the cover in halves until it is slightly larger
than the FlagBag.
- Fold
the edges towards the center as best you can then begin to roll it
into the bag. See the images below for these final steps...
|
|
|
|
|
|
|
|
|
|
 |
 |
 |
|
Once the cover has been
laid out and folded up...
|
The key is to fold the
edges inward...
|
Then begin to tuck
the cover by rolling
it towards the bag...
|
|
 |
 |
 |
|
Keep rolling...
|
and tucking...
|
and VIOLA!
It's in!
|
|
Now that
wasn't so
bad was it, Oliver?
...
Oliver?
Why are you looking at me like that?
Oh, I haven't forgotten our walk.
With the cover
all tucked away,
we have plenty of time
left for that walk!!
Let's GO
buddy!!
|
|
|
|
|
